在电骡上可以搜索得到,我刚下载完,是5张盘的,还没有安!下面是其说明:
Geoworks Ensemble 2.0
Geoworks May 1993
* Minimum Hardware:
+ 286 CPU (386 recommended)
+ CGA display and adapter
+ 1 megabyte memory
+ 15 megabytes free disk space
+ Floppy drive compatible with host PC
+ Available serial port
* Minimum Software:
+ MSDOS 3.0 or DR DOS 5.0
5 - Disks, use 1.2Mb or 1.44Mb floppies
Unzip each to a new or newly formatted floppy
You must install from floppy for this to
install. If you get an error during installation
be sure to have a printer attached to LPT 1,
seems if you don't you can get an error even if
no printer driver is installed.
Labels for disks:
Disk1= Geos_1
Disk2= Geos_2
Disk3= Geos_3
Disk4= Geos_4
Disk5= Geos_5
Troubleshooting startup:
Q: During Setup I get a divide by "0" error.
A: Make sure you have a printer connected and turned on.
Or change the line in GEOS.INI that reads:
continueSetup = true to read:
continueSetup = false
and install the printer thru Geos and not Setup.
Q: When I try to start GEOS, I get a message saying that GEOS is
unable to find /userdata/fonts
A: This could be any of several things. GEOS interacts with the
hardware at a very low level, and it doesn't work well with anything
that redirects the drives. Specifically:
* Windows 32 bit file access SOMETIMES causes problems.
* Networked drives cause problems for GEOS system files, although
you can usually save data to a networked drive.
* DOS emulation under Linux or Macintosh causes problems because
GEOS tries to directly interact with hardware that just isn't
there.
Q: I switched from MS-DOS/PC-DOS to DR-DOS and GEOS won't load, even
after i run SETUP. What am I doing wrong?
A: Make sure that you have FILES=120 or MORE. DR-DOS uses files
differently and needs more available. NWDOS USUALLY works with about
50 files open.
Enjoy.....Ho !