中国DOS联盟

I recently downloaded an MS-DOS 7.10, but I don't know how to use DOSIMG to extract two image files to the C drive. Please help from the experts. Many thanks!!!!!!!!!!!!!!

I was using dosimg in the command prompt in WIN98 at that time. It didn't work in pure DOS. I don't really understand the specific problem. I'm also a beginner. Actually, it's very simple. For example, if your dos71_1.img and dos71_2.img are in the msdos71f folder on the C drive, then dosimg dos71_1.img c:\dos71 and dosimg dos71_2.img c:\dos71 will extract these 2 IMG files to the DOS71 folder on the C drive. Then enter this folder in pure DOS and SETUP. PS: I don't understand why dosimg doesn't work in pure DOS on my side~ It has to be used in the command prompt of 98~! I'm depressed!

Is your C drive in NTFS format? DOS can't recognize NTFS format.

The following is a quote from ayd11's post on August 21, 2004 at 23:47:39:

I was using dosimg in the command prompt in WIN98. I couldn't get it to work in pure DOS, and I don't really understand the specific problem~

Probably DOSIMG is a 32-bit DOS application, so it can't run in pure DOS and can only run in Windows.

Brother upstairs! But I see many places saying that DOSIMG is a program in DOS~ There's no reason it's a 32-bit DOS application~ If that's the case, it doesn't count as a DOS application at all!~ I believe this software should have been around before Windows~?

What is said above doesn't seem right. It should be to use hd-copy to copy to the floppy disk, and then in stup