The system shows verifying dmi pool data and then just hangs! - China DOS Union Forum

My computer is rather old. I had installed a cracked version of Restore Wizard before. Today I attached this hard disk to another machine and used pqmagic7.0 to repartition and format it, then transferred DOS 7.0 onto it. When booting from this hard disk, I found that after startup self-check, when it reaches verifying dmi pool data, it just stops there, with the cursor flashing nonstop. It simply cannot get past it. What is going on, and what should I do?
Also, when I restored another machine's clone onto this machine: a: the clone from the original machine when it did not have Restore Wizard can boot normally and enter window, but when installing Restore Wizard it says a similar version is already installed, and if I want to install it I must uninstall it first. But there is already no Restore Wizard on the hard disk, while the original system had no problem at all when installing Restore Wizard. This is very strange, and I just can't figure it out. b: if after repartitioning and formatting the hard disk, I restore a clone system that has Restore Wizard, it also stops at verifying dmi pool data ... and cannot continue.
I hope everyone can help solve this and analyze it a bit, thanks in advance!
Note: my ghost file was made from the entire hard disk

Floor1　无雨生	Posted 2003-11-12 00:00
初级用户　Posts 9　Credits 134
My computer is rather old. I had installed a cracked version of Restore Wizard before. Today I attached this hard disk to another machine and used pqmagic7.0 to repartition and format it, then transferred DOS 7.0 onto it. When booting from this hard disk, I found that after startup self-check, when it reaches verifying dmi pool data, it just stops there, with the cursor flashing nonstop. It simply cannot get past it. What is going on, and what should I do? Also, when I restored another machine's clone onto this machine: a: the clone from the original machine when it did not have Restore Wizard can boot normally and enter window, but when installing Restore Wizard it says a similar version is already installed, and if I want to install it I must uninstall it first. But there is already no Restore Wizard on the hard disk, while the original system had no problem at all when installing Restore Wizard. This is very strange, and I just can't figure it out. b: if after repartitioning and formatting the hard disk, I restore a clone system that has Restore Wizard, it also stops at verifying dmi pool data ... and cannot continue. I hope everyone can help solve this and analyze it a bit, thanks in advance! Note: my ghost file was made from the entire hard disk

Floor2　seagit	Posted 2003-11-26 00:00
初级用户　Posts 3　Credits 113
Using ghost clone to overwrite data or format the hard disk cannot clear Restore Wizard. When booting, press the Home key and you can enter the Restore Wizard interface. If Restore Wizard has not been uninstalled, it will forbid any operation on the hard disk MBR and partition table, so after cloning it cannot boot. Even if you install from CD, the result is the same. If you remember the wizard's password, just remove it directly; if you don't remember it, you can look for related uninstall software. Copying files in Windows to a disk protected by Restore Wizard is only a virtual operation. Actually, if you look at those copied files under DOS, they simply do not exist. Since your DOS files were never actually copied over, your DOS system cannot boot. Uninstall Restore Wizard first!