I use XP (installed in C:\), and I don't have a floppy drive!
Under the XP environment, I first extracted the files in the image to a folder on the hard disk, for example d:\dos
Then I ran SETUP.BAT
But after following the prompts all the way through the installation,
only these were created in the target folder:
a folder (empty) "~dosetmp"
a temp file (1k) "~~W~~.TMP"
I've never used DOS, please tell me where I went wrong?
Under the XP environment, I first extracted the files in the image to a folder on the hard disk, for example d:\dos
Then I ran SETUP.BAT
But after following the prompts all the way through the installation,
only these were created in the target folder:
a folder (empty) "~dosetmp"
a temp file (1k) "~~W~~.TMP"
I've never used DOS, please tell me where I went wrong?


