China DOS Union

Question 1、
Why doesn't win2k sev run autoexec.bat?
Question 2、
My c-view 2.23 can't exit with ESC or mouse (USB) under DOS6.22. Once I press ESC or mouse, it freezes, and resetting or hot restarting doesn't work, only powering off forcefully. c-view 2.23 under win2k sev must be right-clicked the second time to exit.
Question 3、
The three tools of srctools can't be used under win2ksev (fat32) and DOS6.22 (fat16), depressed,

The compatibility of MS-DOS 6.22 is not very good, and the functions are not very strong. Try upgrading the system to MS-DOS 7.10 and then running C-View and SRCTools.

Okay, thank you. I'll take a look after the upgrade.

Also, why doesn't win2k sev run the autoexec.bat when it starts up?

2000 doesn't have DOS..

Win2K only has a virtual "DOS command prompt"! In fact, it's just a 32-bit Win32 DOS Console.

In 2000, there is no DOS, so its autoexec.bat is just a decoration.

Also, how to upgrade to 7.10 well, I still don't understand it very much.

Please let the master like RuShi or wengier help to answer, thank you

The following is a quote from yieme on 2003-5-24 20:59:36:

Also, how to upgrade 7.10 well, I still don't understand after looking at it.

What does "upgrade 7.10" mean???

Upgrade to 7.10,
If you boot with the 7.10 boot disk and then sys x: (the drive letter where I installed DOS 622),
Then copy the full version of 7.10 made by Wengier over,
Is there any problem with doing this?

The following is a quote from Wengier on 2003-5-24 11:40:22:
The compatibility of MS-DOS 6.22 is not very good, and the functions are not very strong. Try upgrading the system to MS-DOS 7.10 and then running C-View and SRCTools.

Sure. First boot with an MS-DOS 7.10 boot floppy, then use commands like SYS and COPY to copy to the hard disk and modify relevant configuration files.

and modify the relevant configuration files accordingly.

Can moderator wengier give more specific details?

Thank you!

Refers to configuring the config and autoexec files.

Now it can only be said to be almost a high-end customization.
I used sys, but the default command.com of the system is on the C: drive.
It can only be used if it is placed on C, sigh.
How to modify io.sys so that it defaults to looking for other drives?
For example, G:
Thank you

It doesn't work, IO.SYS only recognizes drive A or drive C. You can use SPFDISK and other tools to virtualize drive C.

It seems that I can only put command.com on c:

Thank you two moderators

My c-view still has this situation under DOS 7.10

My c-view 2.23 cannot exit with esc or mouse (USB) under DOS 6.22.
Once I press esc or mouse, it freezes. And the hot start and reset cannot be used.
I can only power off forcibly.

Is there any solution?
Thanks!