China DOS Union

As shown in the figure! After restarting, it prompts to reinsert the disk. I don't know the reason! By the way, my MS-DOS installation disk is in ISO format. I specified the ISO path in the first figure, but it can't be installed?? What's the reason?? How can I install it properly?? Thanks a lot!







ps: At first, my C drive was in NTFS format. Later, I reinstalled the system and the C drive was in FAT32 format, but it still can't be installed! The same prompt! This ISO file was downloaded from this site!

[ Last edited by shijianxin on 2006-7-17 at 19:16 ]

Enter the BIOS of the virtual machine and check if the first boot is CD-ROM. If not, try setting it to CD-ROM.

Originally posted by wsklll at 2006-7-17 22:20:
Enter the BIOS of the virtual machine and check if the first boot is CD-ROM. If not, set it to be so and try.

Can't enter! When the virtual machine boots, pressing F2 directly jumps to the above screen

Originally posted by shijianxin at 2006-7-31 07:25 PM:

Can't get in! After the virtual machine starts, pressing F2 directly jumps to the above screen

After VMware starts, press F2 immediately to enter the BIOS, and set the CD-ROM as the first boot in it.

I prefer to use VPC to install MS-DOS, and can install UCDOS, haha