Why is it that when I run 16-bit programs on my 2000, nothing happens?
It probably just can't display them, right?
If I use the command > *.txt, it can output the result of the program to a txt file
but if I execute it directly, nothing is displayed on the screen
But after running edit
then running these command-line programs again, I can see them all
Can anyone tell me why this is?????
It probably just can't display them, right?
If I use the command > *.txt, it can output the result of the program to a txt file
but if I execute it directly, nothing is displayed on the screen
But after running edit
then running these command-line programs again, I can see them all
Can anyone tell me why this is?????
