China DOS Union

Making a pure DOS is very simple. Just use a small software: One - Key GHOST 11.5 Hard Disk Edition
http://www.jzwc158.com/ShowSoft.asp?id=464 Download address.
After installation, it is a dual - system boot, and you can choose DOS or XP

It's a troublesome thing that DOS can't support the NTFS format

Originally posted by wind198341 at 2005-12-4 20:38:
The cause of the problem: I have installed the WINXP-SP2 system (all disks are in FAT32 format), and I want to add a DOS system to make it a dual system. Seeing the introduction of your MS-DOS 7.10, it is said that it can be directly based on XP...

1. There is no problem in your situation. You have seen that it has booted from the CD. As for the fact that you said you need to ask whether to boot from the CD, that is the CD boot program asking you. Because this iso boot program directly enters DOS, so you don't see the interface asking you.
2. After this CD boots, it is directly installed, and you don't need to manually enter setup. Besides, this CD runs by simulating a floppy disk, the drive letter is A, not H. Please first enter A:, then setup.

Originally posted by fanshuling at 2006-4-2 10:49:
I have some problems! It says to boot to DOS from the CD, and then it's
a:\Sys a: c:
a:\Srcboot c: c:\bootsect.dos /s
Bad command or file name
I'm relatively new, and I humbly request an answer

Srcboot is still in the ebd.zip, not extracted, or there is no ebd.zip file at all.

Originally posted by chujiafu at 2008-6-22 09:13:
After installing Vfloppy and creating an image, after restoration, Vfloppy still doesn't work.

Vfloppy records the sector positions. After restoring the image, the file exists but the sector positions change, so Vfloppy can't find the floppy disk image. It is suggested to use GRUB

Suggest the thread starter to delete all the water posts. There are more than 300 floors, too much garbage. It makes me spend half a day seeing nothing useful.

Originally posted by twgsgi at 2008-5-11 11:47:
I wonder if this method can still be used after ghost backup and restoration?

It can be used

Originally posted by long3021 at 2008-3-16 14:30:
.Echo c:\="MS-DOS">>c:\boot.ini

It seems like echo c:\bootsect.dos="ms_dos". Sometimes I also see that BOOTSECT.DOS is omitted, the same as the LZ. Why can it be omitted?

Both are acceptable. The ntldr will default to looking for the bootsect.dos file, so it can be omitted

Just virtualize DOS, the environment is差不多. (Note: "差不多" here is left as is since it's not a strict translation but part of the original context. The overall translation is based on the given content while keeping the non-translatable parts as they are.)

Hehe... Good stuff

forever forever forever

Got it, thanks!

Through unremitting efforts, it was finally successful. The Dos that can be used on NTFS and FAT32 file systems is available. Usage method: After downloading Gruboot.rar, extract it, and then run Gruboot.cmd inside. The attachment can only be less than 300K and has been uploaded to the forum upload file area.

Support!

Not bad, come and give it a thumbs up.