试用SBMSR v3.11发现以下问题：连续启动两次，都是采用默认的选项，都是死机，启动到：Now setting up the RAM diskThe necessary tools have been successfully loaded to drive H:MouseClip is installedDOSLFN 0.32oWrong content of file GB2312）
i1/4 or cannot read!high loaded consuming 17520 bytes.到这时就死机了。还有一次，启动的是Ms-dos7.10的启动盘，再往后选择的是第二项，Real Mode，未用V.C。能启动成功，但到最后，出现了不停滚动的A:>\Your program caused a divide everflow errorIf the program persists,contact your prgram vendor.这两行字不停地向上滚动，不能进行任何的操作。连Ctrl+Alt+Del三个键都不能停住。
When testing with SBMSR v3.11, the following problems were found: Starting twice continuously, both using the default options, both resulted in a system crash. It reached: Now setting up the RAM disk The necessary tools have been successfully loaded to drive H: MouseClip is installed DOSLFN 0.32 o Wrong content of file GB2312）
i1/4 or cannot read! high loaded consuming 17520 bytes. It crashed at this point. Another time, starting with the boot disk of Ms-dos7.10, then selecting the second item later, Real Mode, without using V.C. It started successfully, but finally, the two lines of text "A:\>Your program caused a divide everflow error If the program persists, contact your prgram vendor." kept scrolling up, and no operations could be performed. Even the Ctrl+Alt+Del three keys could not stop it.
