中国DOS联盟

How to achieve Chinese reading and editing under pure DOS 6.22?

I remember there was a Chinese editing software njstar 1.0 that could run under pure English DOS before?

Does anyone still have it?

Thanks!

What system are you using? Why is the DOS version so old? You should upgrade it properly.

Old?

DOS 6.22 version, this is the highest version that can be used on that old computer ;)

8086 instructions are not supported in Windows' DOS anymore

It must be old then! Try this latest version of MS-DOS. It definitely supports 8086 instructions.

http://newdos.yginfo.net/dosart32.htm

How is displaying Chinese characters under DOS achieved?

The following is a quote from gad on 2004-1-26 13:41:06:
How to achieve Chinese reading and editing under pure DOS 6.22?

I remember there was a Chinese editing software njstar 1.0 that could run under pure English DOS before?

Does anyone still have it?

Thanks!

Give this a try.
Open the attachment

My 386 can use MS-DOS 7.0

The following is a quote from gad on 2004-1-26 13:41:06:
How to achieve Chinese reading and editing under pure DOS 6.22?

I remember there was a Chinese editing software njstar 1.0 that could run under pure English DOS before?

Does anyone still have it?

Thanks!

You can use CCDOS97 for editing and CL for reading.

I should have NJSTAR 1.0, which seems to support BIG5 code and HZ code. Two disks.