『楼 主』:
新蓝G6000笔记本电脑无光驱、软驱,如何安装WIN2000?
使用 LLM 解释/回答一下
各位大虾,我有一笔记本电脑,为新蓝G6000型,无光驱、软驱,带USB2.0接口,支持USB软驱启动,曾经使用内置光刻加外置USB2.0硬盘合当作外置光驱安装WINXP,可以正常安装,但是,格掉硬盘后用上述光驱安装WIN2000时,文件拷贝完成后,重新启动即出现蓝屏,显示硬件错误,之后使用EKE外置光驱安装WIN2000时,不能直接用光盘启动,用外置软驱启动后,经常找不到光驱,也曾用过将WIN2000下I386文件拷贝到硬盘后,重新启动到DOS下进行安装的方法,但是,也是在拷贝完安装文件后出现蓝屏,请问上述问题如何解决,谢谢赐教。笔记本配置为P4-M2.2G,256MDDR,40G硬盘,SIS650芯片组,集成显卡、网卡、猫,带GPRS模块。
Dear all, I have a notebook computer, which is the New Blue G6000 model, without a CD-ROM or floppy drive, with a USB2.0 interface, and supports USB floppy drive boot. I once used the built-in optical engraving combined with an external USB2.0 hard disk as an external CD-ROM to install WINXP, which could be installed normally. However, after formatting the hard disk and using the above CD-ROM to install WIN2000, after the file copying is completed, it restarts and a blue screen appears, showing a hardware error. Then, when using the EKE external CD-ROM to install WIN2000, it cannot be directly booted from the CD, and when booted from the external floppy drive, it often cannot find the CD-ROM. I have also used the method of copying the I386 files under WIN2000 to the hard disk and then restarting to DOS for installation, but it also has a blue screen after copying the installation files. Please tell me how to solve the above problems, thank you for your advice. The notebook configuration is P4-M2.2G, 256M DDR, 40G hard disk, SIS650 chipset, integrated graphics card, network card, modem, and with a GPRS module.
|