中国DOS联盟

我的配置如下:
可打开SlimFTPd.exe时，总是提示配置错误！
BindInterface All BindPort 6990 CommandTimeout 300 ConnectTimeout 15 MaxConnections 20 LookupHosts off <User "efw"> Password "efw123" Mount / C:\ftproot Mount /upload c:\ Allow / Read List Allow /upload Write Deny /private All Mount /files D:\files </User>

原 slimftpd.conf ：

######################################### ## ## ## SlimFTPd Configuration Script ## ## ## ######################################### # # Global server variables # # # The BindInterface directive specifies which network interface should be used # to listen for incoming connections. Available options are All, LAN, WAN, # Local, or you can specify an IP address. # BindInterface All # # The BindPort directive specifies which TCP port should be used to listen for # incoming connections. The standard FTP port is 21. # BindPort 6990 # # The CommandTimeout directive specifies how many seconds to wait for a # connected client to issue a command before dropping the connection. The # default is 300 (5 minutes). # CommandTimeout 300 # # The ConnectTimeout directive specifies how many seconds to wait for a data # socket to connect with a client. This value applies to both active- and # passive-mode connections. The default is 15. # ConnectTimeout 15 # # The MaxConnections directive specifies an upper limit on the number of # connections that may be made to the server at any one time. The default is # 20. # MaxConnections 20 # # The LookupHosts directive tells SlimFTPd whether it should look up the # corresponding host names for IP addresses when logging connections. Note # that this may take slightly more network bandwidth and may cause a short # delay for users during initial connection. The default is On. # LookupHosts off # # User accounts # # # You may refer to the following example of a user account setup. Note that # backslashes must be escaped for proper interpretation by the script parser # only when they occur in a double-quoted string. For example, C:\ is legal, # but "C:\" is not legal. Use "C:\\" instead. # # Use the Mount directive to attach a local file system path to a virtual file # system path. Refer to the examples below. # # Use the Allow and Deny directives to set permissions on paths in the virtual # file system. Valid permission tokens are Read, Write, List, Admin, or All to # indicate all four permission types. # # Use the Password directive to set a password for a user. If no password is # set, the user will be allowed to login without a password. # # Examples: # #<User "bob"> # Password "abc123" # The next directive will cause all files and folders in C:\ftproot to appear # in the server's root. # Mount / C:\ftproot # Now we'll allow Read and List permissions for the root and all folders # beneath it. We'll also explicitly allow Write permission for only the # /upload folder (which in this example exists at C:\ftproot\upload) and # all folders beneath it. Finally, we'll explicitly deny access of any kind # to the /private folder (which would be located at C:\ftproot\private). # Allow / Read List # Allow /upload Write # Deny /private All # Here's another mount point that would appear in the server's root as /files. # Note that this mount point will automatically allow Read and List # permissions as it inherits the server root's permissions defined above. # Mount /files D:\files #</User> #