小弟昨天下载了PQmagic for dos的程序及其命令行的相关资料,尝试运行编写PQS对一个40G的硬盘（该硬盘没有分过区）进行自动分区,文件内容如下:
test.pqs
-------------------
Select Disk 1
//select current hard disk
Delete All
//Delete all the partition
Create /FS=FAT32 /Label="C" /Size=5120
Set Active
//Create the primary C,and set it active
Select Unallocated After Selected Parition
Create /FS=extended
//create extended partition
Select Unallocated After Selected Parition
Create /FS=FAT32 /Label="D" /Size=GetSeletedUnallocatedSize*0.5
//create logic D,and resize it half of unallocated
Select Unallocated After Selected Parition
Create /FS=FAT32 /Label="E"
//the rest is the logic E
----------------------------------
在dos命令行下输入:
pqmagic /cmd=test.pqs后进入PQMAGIC,不到2秒便退回到提示符的界面,提示"test.pqs is unknown"
(该脚本文件与pqmagic处于同一目录下)
不知道是那里出了问题,希望高手指点指点......小弟跪谢了......
test.pqs
-------------------
Select Disk 1
//select current hard disk
Delete All
//Delete all the partition
Create /FS=FAT32 /Label="C" /Size=5120
Set Active
//Create the primary C,and set it active
Select Unallocated After Selected Parition
Create /FS=extended
//create extended partition
Select Unallocated After Selected Parition
Create /FS=FAT32 /Label="D" /Size=GetSeletedUnallocatedSize*0.5
//create logic D,and resize it half of unallocated
Select Unallocated After Selected Parition
Create /FS=FAT32 /Label="E"
//the rest is the logic E
----------------------------------
在dos命令行下输入:
pqmagic /cmd=test.pqs后进入PQMAGIC,不到2秒便退回到提示符的界面,提示"test.pqs is unknown"
(该脚本文件与pqmagic处于同一目录下)
不知道是那里出了问题,希望高手指点指点......小弟跪谢了......