|
wewebb
初级用户
 
积分 66
发帖 53
注册 2009-10-9
状态 离线
|
『第 511 楼』:
使用 LLM 解释/回答一下
绝对扇区读写好工具。说明写得很详细。
A great tool for absolute sector reading and writing. The instructions are very detailed.
|
|
2009-10-10 19:54 |
|
|
woo88
初级用户
 
积分 188
发帖 96
注册 2008-3-11
状态 离线
|
|
2009-10-29 18:51 |
|
|
Portable
新手上路

积分 11
发帖 6
注册 2009-11-4
状态 离线
|
|
2009-11-6 04:26 |
|
|
jianliulin
新手上路

积分 5
发帖 3
注册 2009-5-18
状态 离线
|
『第 514 楼』:
使用 LLM 解释/回答一下
找了好久的软件
The software I've been looking for for a long time
|
|
2009-11-20 15:38 |
|
|
jianliulin
新手上路

积分 5
发帖 3
注册 2009-5-18
状态 离线
|
『第 515 楼』:
使用 LLM 解释/回答一下
lz,能否把限定名称执行的功能去掉,当我把dsptw载入内存再执行的时候,程序就被拦住了
LZ, can you remove the function of executing with a limited name? When I load dsptw into memory and then execute it, the program gets blocked.
|
|
2009-11-20 19:33 |
|
|
atoms
初级用户
 
积分 182
发帖 28
注册 2002-12-13
状态 离线
|
『第 516 楼』:
有没有13KB以下纯dos 用的diskrw.com
使用 LLM 解释/回答一下
有没有13KB以下纯dos 用的diskrw.com
在64kb,freedos中用的
Is there a diskrw.com for pure DOS below 13KB, used in 64kb, freedos?
|
|
2009-11-21 02:20 |
|
|
123456
初级用户
 
积分 128
发帖 9
注册 2003-11-16
状态 离线
|
『第 517 楼』:
使用 LLM 解释/回答一下
你是一下这个版本,我更改了查找顺序
You are the version below, I changed the search order
|
|
2009-12-1 15:19 |
|
|
guapibai
新手上路

积分 16
发帖 8
注册 2009-5-2
状态 离线
|
|
2009-12-4 17:28 |
|
|
gaoruxing
新手上路

积分 2
发帖 1
注册 2009-12-13
状态 离线
|
|
2009-12-17 10:09 |
|
|
AhKang
初级用户
 
积分 42
发帖 21
注册 2008-3-31
状态 离线
|
『第 520 楼』:
麻烦楼主帮看一下! C: 盘哪里去了? (附图)
使用 LLM 解释/回答一下
放到 E: 盘下的大多数目录(中文/英文)均可正常运行(正常显示 C: 分区, 但个别目录除外), 而一旦放到 D: 盘和 C: 盘的任意位置(包含根目录)运行均是这个样子--不显示 C: 分区(是参数错误了吗? 但在 E: 盘下运行相同的命令没出错呀!), 恳请楼主于百忙之中抽空看一下, 给予解决为谢!
Last edited by AhKang on 2009-12-25 at 16:22 ]
Most directories (Chinese/English) placed under drive E: can run normally (C: partition is normally displayed, but there are exceptions for individual directories). However, once placed in any location (including the root directory) of drive D: or C:, it appears like this - C: partition is not displayed (is it a parameter error? But the same command runs without error under drive E:!). I sincerely request the original poster to take time from their busy schedule to take a look and provide a solution.
Last edited by AhKang on 2009-12-25 at 16:22 ]
附件
1: NoC.PNG (2009-12-25 16:16, 9.17 KiB)
附件
2: HasC.PNG (2009-12-25 16:21, 59.76 KiB)
附件
3: CNDirHasC.PNG (2009-12-25 16:21, 66.04 KiB)
|
|
2009-12-25 16:16 |
|
|
cjing2000
新手上路

积分 2
发帖 1
注册 2009-2-17
状态 离线
|
『第 521 楼』:
使用 LLM 解释/回答一下
下载测试下,没想到两个整合在一起文件小了那么多啊.
Download and test it. Unexpectedly, the two integrated files are so much smaller.
|
|
2009-12-26 14:04 |
|
|
19951001
高级用户
    流落街头
积分 570
发帖 272
注册 2005-10-17 来自 北京
状态 离线
|
『第 522 楼』:
使用 LLM 解释/回答一下
我这里没有这种情况发生
There is no such situation here.
附件
1: 111.GIF (2009-12-26 15:52, 16.36 KiB, 下载附件所需积分 1 点
)
|
|
2009-12-26 15:52 |
|
|
wyl0205
新手上路

积分 2
发帖 1
注册 2009-12-24
状态 离线
|
『第 523 楼』:
使用 LLM 解释/回答一下
不知道能不能检测到硬盘数量
I don't know if the number of hard drives can be detected
|
|
2009-12-28 13:03 |
|
|
AhKang
初级用户
 
积分 42
发帖 21
注册 2008-3-31
状态 离线
|
『第 524 楼』:
回楼上的:可以检测磁盘数量
使用 LLM 解释/回答一下
对应命令为:
dsptw n /L (n=0(第1块硬盘,n=1为第2块硬盘…依此类推)直到最大硬盘数,如果命令出现“Open Disk Error!”,则说明您的硬盘数为刚才输入的数字。
比如,只有一块硬盘的计算机中,输入 dsptw 0 /L 是没有问题的,但如果输入 dsptw 1 /L 则会出现 Open Disk Error! 也就量说,您的硬盘就是您刚才输入的 1 (只有1块硬盘喽)
至少我是这样理解的,如有不妥之处,还望坛上高人们批评指正。
Last edited by AhKang on 2010-1-4 at 16:21 ]
The corresponding command is:
dsptw n /L (n = 0 (the first hard disk, n = 1 is the second hard disk... and so on) until the maximum number of hard disks. If the command appears "Open Disk Error!", it means that the number of your hard disks is the number you just entered.
For example, in a computer with only one hard disk, entering dsptw 0 /L is okay, but if you enter dsptw 1 /L, then "Open Disk Error!" will appear. That is to say, your hard disk is the number you just entered, which is 1 (only one hard disk, right?)
At least this is how I understand it. If there are any improper places, I hope the experts on the forum will criticize and correct.
Last edited by AhKang on 2010-1-4 at 16:21 ]
|
|
2010-1-4 16:20 |
|
|
3mile
新手上路

积分 2
发帖 1
注册 2010-1-6
状态 离线
|
『第 525 楼』:
使用 LLM 解释/回答一下
好东西,尤其是GETID非常有用哈
Good stuff, especially GETID is very useful ha
|
|
2010-1-11 22:10 |
|