Startup steps:
1。Boot MSDOS7.1 C:\MSDOS7.1
2。Run the TC2。0 interface (the purpose is to run the program in the next step; actually I don't want its interface to appear) placed at c:\tc2.0\TC.EXE
3. Run my own application c:\tc2.0\a.exe
I only want it to boot straight into this, without showing any screen at all, and without entering any commands!
Could some batch file expert please explain the specific steps, preferably with the program!!! Thanks!
(My application accepts serial control from another PC, and when it receives one character it outputs graphics; I only want to see that.)
1。Boot MSDOS7.1 C:\MSDOS7.1
2。Run the TC2。0 interface (the purpose is to run the program in the next step; actually I don't want its interface to appear) placed at c:\tc2.0\TC.EXE
3. Run my own application c:\tc2.0\a.exe
I only want it to boot straight into this, without showing any screen at all, and without entering any commands!
Could some batch file expert please explain the specific steps, preferably with the program!!! Thanks!
(My application accepts serial control from another PC, and when it receives one character it outputs graphics; I only want to see that.)


