Can't see other partitions under DOS - China DOS Union Forum

The system is set up with dual boot, DOS (from the Win98 recovery disc) and WIN2000, which makes it convenient to do backup and restore under DOS.
The hard disk is divided into three partitions: C, D, and E. Under WIN2000 they are all accessible, and they are all FAT32 partitions. But after restarting and entering DOS, I found that D and E could no longer be accessed. However, with GHOST, DISKMAN, etc., I can still see the other partitions.
What's going on here? How can I make DOS see the other partitions?

Also, I used DISKMAN to look at the partition table. 1 is PRIMARY, 2 is EXTEND, 3 and 4 are empty, and 5 is the D drive, 6 is the E drive.
Could this be affecting it?

Floor1　chinalgd	Posted 2003-12-04 00:00
初级用户　Posts 1　Credits 104
The system is set up with dual boot, DOS (from the Win98 recovery disc) and WIN2000, which makes it convenient to do backup and restore under DOS. The hard disk is divided into three partitions: C, D, and E. Under WIN2000 they are all accessible, and they are all FAT32 partitions. But after restarting and entering DOS, I found that D and E could no longer be accessed. However, with GHOST, DISKMAN, etc., I can still see the other partitions. What's going on here? How can I make DOS see the other partitions? Also, I used DISKMAN to look at the partition table. 1 is PRIMARY, 2 is EXTEND, 3 and 4 are empty, and 5 is the D drive, 6 is the E drive. Could this be affecting it?

Floor2　Wengier	Posted 2003-12-05 00:00
系统支持　Posts 10,521　Credits 27,736
Try an MS-DOS 7.10 boot disk.