Our workplace uses NetGhost 7.0 network cloning to maintain the system~
I ran into a problem: there is a kind of Mercury C29 network card that still can't use the network normally after installing the DOS driver, so network cloning can't be used. This network card supports diskless remote boot. I'm not familiar with DOS or diskless workstations, so I don't know where the problem is. The same kind of 8139 network card works normally.
PCI 10/100 Fast Ethernet Adapter Packet Driver v1.10 (010302)
Copyright (C) 2000 Fast Ethernet Controller Provider. All Rights Reserved.
Performing Automatic Media Detection...
Switching to 100BaseTx Full Duplex ...
My Options
Packet Driver Interrupt Number 0x60
I/O Port 0xC000
Hardware Interrupt Number 11
Medium Type is 100baseTx Full Duplex
My Ethernet Address is 00:E0:50:00:49:BB
Packet Driver is loaded at segment BE0
I ran into a problem: there is a kind of Mercury C29 network card that still can't use the network normally after installing the DOS driver, so network cloning can't be used. This network card supports diskless remote boot. I'm not familiar with DOS or diskless workstations, so I don't know where the problem is. The same kind of 8139 network card works normally.
PCI 10/100 Fast Ethernet Adapter Packet Driver v1.10 (010302)
Copyright (C) 2000 Fast Ethernet Controller Provider. All Rights Reserved.
Performing Automatic Media Detection...
Switching to 100BaseTx Full Duplex ...
My Options
Packet Driver Interrupt Number 0x60
I/O Port 0xC000
Hardware Interrupt Number 11
Medium Type is 100baseTx Full Duplex
My Ethernet Address is 00:E0:50:00:49:BB
Packet Driver is loaded at segment BE0


