Our organization uses NetGhost 7.0 network cloning to maintain systems~
A problem I ran into is that there is a Crystal C29 network card which still cannot use the network normally even after the DOS driver is installed, so network cloning cannot be used. This NIC supports diskless remote boot. I'm not familiar with DOS or diskless workstations, so I don't know where the problem is. The same model 8139 NIC works normally.
PCI 10/100 Fast Ethernet Adapter Packet Driver v1.10 (010302)
Copyright (C) 2000 Fast Ethernet Controller Provider. All Rights Reserved.
Performing Automatic Media Detection...
Switching to 100BaseTx Full Duplex ...
My Options
Packet Driver Interrupt Number 0x60
I/O Port 0xC000
Hardware Interrupt Number 11
Medium Type is 100baseTx Full Duplex
My Ethernet Address is 00:E0:50:00:49:BB
Packet Driver is loaded at segment BE0
A problem I ran into is that there is a Crystal C29 network card which still cannot use the network normally even after the DOS driver is installed, so network cloning cannot be used. This NIC supports diskless remote boot. I'm not familiar with DOS or diskless workstations, so I don't know where the problem is. The same model 8139 NIC works normally.
PCI 10/100 Fast Ethernet Adapter Packet Driver v1.10 (010302)
Copyright (C) 2000 Fast Ethernet Controller Provider. All Rights Reserved.
Performing Automatic Media Detection...
Switching to 100BaseTx Full Duplex ...
My Options
Packet Driver Interrupt Number 0x60
I/O Port 0xC000
Hardware Interrupt Number 11
Medium Type is 100baseTx Full Duplex
My Ethernet Address is 00:E0:50:00:49:BB
Packet Driver is loaded at segment BE0