There is some problem with my hard disk (unknown), and its format is NTFS. Because the hard disk is not easy to remove, I considered using a USB device to copy the data off the hard disk.
The boot disk I used was downloaded here. After booting, the screen went black. After removing the LOGO, I was finally able to get in.
Among them, DUSE4.4 can find my usb hard disk (Aigo USB hard disk), and it reports it as ibm dujs 210. After that the system treats it as drive F. But after startup, drive F cannot be used. It behaves like this:
>F:
(roughly meaning drive F is unavailable, or not ready)
Unplug it
DUSE reports the device is not present.
Plug it in again
duse reports the device as ibm dujs 210, mounted on drive F
At this time I can switch to F
then dir
I can see the hard disk volume label, but the directory cannot be listed, and it reports that drive F is unavailable.
Moderator, what should I do so that I can use my usb hard disk
The boot disk I used was downloaded here. After booting, the screen went black. After removing the LOGO, I was finally able to get in.
Among them, DUSE4.4 can find my usb hard disk (Aigo USB hard disk), and it reports it as ibm dujs 210. After that the system treats it as drive F. But after startup, drive F cannot be used. It behaves like this:
>F:
(roughly meaning drive F is unavailable, or not ready)
Unplug it
DUSE reports the device is not present.
Plug it in again
duse reports the device as ibm dujs 210, mounted on drive F
At this time I can switch to F
then dir
I can see the hard disk volume label, but the directory cannot be listed, and it reports that drive F is unavailable.
Moderator, what should I do so that I can use my usb hard disk
