Regarding the problem that SMARTDRV cannot be loaded in DOS! And the error report!!
config.sys
device=himem.sys
device=emm386.exe noems novcpi i=b000-b7ff
Dos=High,Umb
I tried several DOS versions, and SMARTDRV could not be loaded in all of them.
The error report is as follows:
SMARTDRV cannot be loaded because the XMS driver, HIMEM.SYS is not loaded, check the config.sys file for a device=HIMEM.SYS command line.
I tried to modify config / replace HIMEM.SYS, but it didn't work:
Error: unable to control A20 line!
XMS driver not installed
I tried to modify config.sys / replace HIMEM.SYS / add the EMM386.exe command line again, but it still didn't work:
An error has occurred, but the correct message could not be found.
Hope to find out the reason why SMARTDRV cannot be loaded!!! Thank you!
config.sys
device=himem.sys
device=emm386.exe noems novcpi i=b000-b7ff
Dos=High,Umb
I tried several DOS versions, and SMARTDRV could not be loaded in all of them.
The error report is as follows:
SMARTDRV cannot be loaded because the XMS driver, HIMEM.SYS is not loaded, check the config.sys file for a device=HIMEM.SYS command line.
I tried to modify config / replace HIMEM.SYS, but it didn't work:
Error: unable to control A20 line!
XMS driver not installed
I tried to modify config.sys / replace HIMEM.SYS / add the EMM386.exe command line again, but it still didn't work:
An error has occurred, but the correct message could not be found.
Hope to find out the reason why SMARTDRV cannot be loaded!!! Thank you!