How to load and install the system from a mobile hard drive after booting a bare machine through USBFDD? - China DOS Union Forum

The equipment is as follows:

One IBM T22 laptop, which only supports booting in USB-FDD mode.

One Netac 64M three-boot USB flash drive, which can be switched to FDD mode via a switch, but the capacity also becomes 1.44M, and other capacities are not visible.

One Baisiling PCMCIA to USB 2.0 card, which has no DOS driver.

One Kingston 4G USB flash drive, which has an i386 directory of XP inside.

The notebook hard drive is all in NTFS format and can no longer boot. Please tell me how to install the system through the above equipment.

The problem is complicated, and a newbie is asking for help.

Floor1　wsabenzhu	Posted 2008-11-28 16:45
初级用户　Posts 2　Credits 106
The equipment is as follows: One IBM T22 laptop, which only supports booting in USB-FDD mode. One Netac 64M three-boot USB flash drive, which can be switched to FDD mode via a switch, but the capacity also becomes 1.44M, and other capacities are not visible. One Baisiling PCMCIA to USB 2.0 card, which has no DOS driver. One Kingston 4G USB flash drive, which has an i386 directory of XP inside. The notebook hard drive is all in NTFS format and can no longer boot. Please tell me how to install the system through the above equipment. The problem is complicated, and a newbie is asking for help.

Floor2　fujianabc	Posted 2008-11-28 17:12
金牌会员　Posts 1,616　Credits 3,467
Plug in two USB drives, boot DOS from the Longshine USB drive. Of course, the DOS should include the USB driver, so that the Kingston USB drive can be powered.