China DOS Union

I kept letting it start automatically, but after it finishes extracting, it only has three options

stay dos shutdown computer Restart Computer

No matter which one I choose, I still can't get into PWIN32, can I??? Then how can this disk even be called a PWIN32 boot disk

Is it an 845 motherboard? Otherwise it shouldn't be like this..

The following is quoted from Wengier's post at 2003-6-16 22:39:02:
Is it an 845 motherboard? Otherwise it shouldn't be like this..

My 815 board is the same too~!

Then exactly at which command does it error out, so that it can't enter the Chinese Win3.2 interface? Anyway, everything works normally on several of my computers.

It works fine for me in a virtual machine; I haven't tried it on a real machine

I tested it in VPC5.2!! After its three prompts, for the last two, no matter whether I press YES or NO, the final result is still those three options. But before showing those three options, it says: pwin32 has been extracted successfully, but right after that it immediately shows that PWIN32 has been successfully removed from the virtual disk …………

This is so infuriating......... if it succeeded, why remove it

The following is quoted from ylpoplove's post at 2003-6-17 15:05:40:
I tested it in VPC5.2!!

No wonder! Please use it in real mode. If you want to use it in VPC, then use VPC 4.x, not VPC 5.x! Because VPC 5.x has a BUG..