China DOS Union

I previously succeeded with the guidance of an expert, but now under the MSDOS7.1 environment it unexpectedly no longer works properly, and I really can't find where the problem is.



This is the batch file code I'm using now



My environment is VPC2007,


I just tested it and found a strange problem:

On the CD, the virtual A: drive, the virtual x, and even when copied to the hard disk, it still cannot run properly,

but if I use Safe Mode at startup, with nothing loaded, then executing the code copied to the hard disk can correctly find the drive letter,


I don't know why this is.

[ Last edited by ww111222 on 2007-8-24 at 01:38 AM ]

You're still working on your Chinese F11? I think it's better to boot with GRUD4dos. You can set hotkeys, write it into the MBR, and it supports Chinese.

I'm running it under hhwwll's Super Chinese MS-DOS7.10 boot disk:

http://www.cn-dos.net/forum/viewthread.php?tid=17237&fpage=1

Originally posted by zjq20032006 at 2007-8-24 01:29 AM:
You're still working on your Chinese F11? I think it's better to boot with GRUD4dos. You can set hotkeys, write it into the MBR, and it supports Chinese.

Yes, I'm also using GRUB4DOS now,


I'm no longer using Nongchaoer's one,


but there is still one problem that hasn't been solved,

namely finding the drive letter for a specified volume label,

Finally figured it out. Turns out there are both find.com and find.exe; using the .exe one works OK.