China DOS Union

Because I often tested it a while ago, so I made N images with GHOST 8.3. (There are both FAT32 and NTFS ones)
A few days ago, after updating to GHOST 11.0, it kept making errors. The error code was: "APPLICATION ERROR 10008"
After reverting to GHOST 8.3, everything was normal, so it's not the problem with the image files!
The image files made by GHOST 11.0 have no problems at all, so it's not the problem with the hard drive!

Fault summary: GHOST 11.0 doesn't recognize the low-level NTFS partition image files, while any image files of the FAT32 partition can be recognized! Please pay attention to avoid unnecessary troubles!


Another note: GHOST 11.0 may have updated the recognition mark (that is, 1:2:\ is equal to 1.2:\) not tested!

[ Last edited by 0451lym on 2007-2-7 at 04:48 PM ]

It can also support the latest 965 motherboards! 8.3 cannot!

Is each version's supported commands also different? Last time I wrote a batch script to restore the system:
ghost.exe -clone,mode=pload,src=f:\ghost\xp.gho,dst=1:1 -sure -rb
It actually prompted that the image file was not found. I remember the English was roughly like this. I wonder if I have to change src=f:\ghost\xp.gho to f:\ghost\xp.gho:1, and also change gho:1 to gh1.

To restore to a partition, you can only use the form of xxx.gho:1.

Thanks to Brother Climbing for solving the doubt