This disk was originally uploaded by you7758. After I completely overhauled it, I am now uploading it to share with everyone.
Original disk address:
http://www2.zzu.edu.cn/ie/newdos/dispbbs.asp?boardID=11&ID=2009
The reasons for the overhaul and the steps are as follows:
Using Menustar to make a Chinese boot interface is also a very good choice. It's just that this disk had quite a few problems. Aside from a few points mentioned by Master Rushi that I also agree with, the most serious one was that KV3000 could not run, saying there was a memory problem.
Later I added EMM386, and conventional memory increased from 470K to 610K. Sure enough, KV3000 could then run.
Then I added the TW Tianhui Chinese-language platform (230K). I also replaced EDIT, HD-COPY, and FDISK on the original disk with Chinese versions. Load TW first and then run the above software, and then it truly becomes a Chinese boot, a Chinese-language platform, and runs Chinese software as well.
After the full overhaul, with the Chinese-language platform loaded, 577K of conventional memory remains; if the Chinese-language platform is not loaded, then
610K of conventional memory remains. Enough to run ordinary software.
The first selection screen in English when booting up is simply unnecessary. If someone wants to boot from the hard disk, who would go out of their way to stick in a floppy disk?
So I removed it. (The original interface did not have boot from floppy at all, only hard disk and CDROM boot options, which was even more confusing.)
Of course, because of the floppy disk's capacity limit, adding the above software was not easy. To "squeeze" a few hundred K of space out of the original disk, quite a bit of software compression and software replacement work had to be done
before it could be added. Since it's rather cumbersome, I won't go into details here. I'll simply upload the final IMG image file for reference.
Original disk address:
http://www2.zzu.edu.cn/ie/newdos/dispbbs.asp?boardID=11&ID=2009
The reasons for the overhaul and the steps are as follows:
Using Menustar to make a Chinese boot interface is also a very good choice. It's just that this disk had quite a few problems. Aside from a few points mentioned by Master Rushi that I also agree with, the most serious one was that KV3000 could not run, saying there was a memory problem.
Later I added EMM386, and conventional memory increased from 470K to 610K. Sure enough, KV3000 could then run.
Then I added the TW Tianhui Chinese-language platform (230K). I also replaced EDIT, HD-COPY, and FDISK on the original disk with Chinese versions. Load TW first and then run the above software, and then it truly becomes a Chinese boot, a Chinese-language platform, and runs Chinese software as well.
After the full overhaul, with the Chinese-language platform loaded, 577K of conventional memory remains; if the Chinese-language platform is not loaded, then
610K of conventional memory remains. Enough to run ordinary software.
The first selection screen in English when booting up is simply unnecessary. If someone wants to boot from the hard disk, who would go out of their way to stick in a floppy disk?
So I removed it. (The original interface did not have boot from floppy at all, only hard disk and CDROM boot options, which was even more confusing.)
Of course, because of the floppy disk's capacity limit, adding the above software was not easy. To "squeeze" a few hundred K of space out of the original disk, quite a bit of software compression and software replacement work had to be done
before it could be added. Since it's rather cumbersome, I won't go into details here. I'll simply upload the final IMG image file for reference.
