Some articles say that with PQ you can select all the detected bad clusters on the hard disk,
then move them into a separate partition, and that this is done
under the graphical interface. But I looked around, and in PQ8.0 and PQ7.0 I only found
the item "check for errors"; I couldn't find what they described as
"select all the detected bad clusters on the hard disk,
then move them into a separate partition."
Which command is it?
then move them into a separate partition, and that this is done
under the graphical interface. But I looked around, and in PQ8.0 and PQ7.0 I only found
the item "check for errors"; I couldn't find what they described as
"select all the detected bad clusters on the hard disk,
then move them into a separate partition."
Which command is it?


