China DOS Union

-- Unite DOS · Advance DOS · Grow DOS --
Union site: www.cn-dos.net　Forum site: www.cn-dos.net/forum

中国DOS联盟论坛
The time now is 2026-08-04 14:20

48,038 topics / 350,123 posts / today 0 new / 48,251 members

DOS批处理 & 脚本技术（批处理室） » Question for the experts about devcon.exe.

Floor1　qjbeprw2	Posted 2006-08-02 01:33
新手上路　Posts 1　Credits 6
I want to disable the network card and enable the network card. How should I use this little program? I downloaded this software, where should I extract it to? How should I use it? The NIC I use is NVIDIAA nforce Networking Controller In an article on this site I saw that devcon find is used to check my NIC's ID. But how do I check it? Create a new bat and type in this command? If I just double-click it, everything flashes past. I can't check it at all. So how should I check it?

Floor2　zh159	Posted 2006-08-02 08:56
金牌会员　Posts 1,467　Credits 3,687
Add a "pause" on a new line, or open the "command prompt" and type it in there

Floor3　ihdx	Posted 2007-05-14 19:10
新手上路　Posts 7　Credits 16
The dencon file can be placed anywhere, or it can be placed in the system folder. When you put it somewhere else, when you run it you have to specify that folder to run it from. If you put it in the system folder, then you don't need to specify the location. To view the NIC, you need to type devcon find pci\* Then it will display the following information: PCI\VEN_10EC&DEV_8139&SUBSYS_80B31043&REV_10\3&1E3AE4CB&0&18F0: Realtek RTL8139 Family PCI Fast Ethernet NIC #2 PCI\VEN_10EC&DEV_8139&SUBSYS_813910EC&REV_10\3&1E3AE4CB&0&28F0: Realtek RTL8139 Family PCI Fast Ethernet NIC The part after the colon is the NIC name, and the part before it is the physical name.