China DOS Union

-- Unite DOS · Advance DOS · Grow DOS --
Union site: www.cn-dos.net　Forum site: www.cn-dos.net/forum

中国DOS联盟论坛
The time now is 2026-10-27 23:04

47,815 topics / 349,929 posts / today 1 new / 48,290 members

DOS启动盘 & LOGO技术（启动盘室） » When booting from a CD - ROM and running Ghost, it often freezes.

Floor1　boxman	Posted 2006-07-04 12:41
新手上路　Posts 6　Credits 15
Sometimes the interface just dies before it's confirmed.. Sometimes it freezes when it needs to be confirmed after saving is complete... Sometimes Ghost freezes halfway through saving.... It's very strange.... I don't know the reason... I've used versions like Ghost 8.0, 2003, 6.... All of these have this phenomenon... Has everyone encountered this situation before..... The system has one hard drive with 2 NTFS partitions.... Of course, when using 6, there was an additional hard drive with a FAT32 partition... One optical drive.. but the optical drive is connected as slave instead of master..

Floor2　fastslz	Posted 2006-07-04 13:37
铂金会员　Posts 2,315　Credits 5,493　From 上海
Is the hard drive or partition confirmed to be okay?

Floor3　boxman	Posted 2006-07-06 10:12
新手上路　Posts 6　Credits 15
The hard drive is fine... For partitioning, do you mean the source partition or the destination partition? They should all be fine... Because the destination partition was formatted before the imaging. The system of the source partition was reinstalled... When installing, I chose to reformat... Of course, it's not a low-level format... There's something I find strange... I have an XP installation disc... When using a BenQ burner to read the disc for installation, it always reports an error at a certain point... But later, I changed to a Sony CD drive and it worked without any problem... But I believe my BenQ burner is fine. It doesn't have similar problems when reading any other disc. The only thing is it was connected as slave. After changing the BenQ to master, it's okay...

Floor4　chujiafu	Posted 2006-07-06 16:24
银牌会员　Posts 595　Credits 1,339　From 安徽　宿州
I also burned Ghost onto a CD, and no problems occurred.

Floor5　雨露	Posted 2006-07-06 19:39
管理员　Posts 2,601　Credits 6,215
Originally posted by boxman at 2006-7-6 10:12: The hard drive is okay... For partitioning, do you mean the source partition or the destination partition? They should also be okay... Because the destination partition was formatted before imaging The system of the source partition is reinstalled... The burner should preferably be connected with a separate IDE cable, not connected to the same cable as the hard drive! And it's best to set it as master, otherwise problems may occur! I have two burners and one hard drive, and I haven't had any problems! [ Last edited by afnspy on 2006-7-6 at 19:42 ]