Some questions about Lynx, please help - China DOS Union Forum

I used to use Lynx to dial up to the Internet, and everything was normal.
Later, after switching to using a network card to access the Internet, I made the corresponding configuration changes (including DNS, gateway, local IP, subnet mask)
But then it stopped working, always prompting that the remote host could not be found. I don't know what's going on.

Also, after I run the Packet driver for the network card under the Win98 DOS-Prompt, the whole system goes offline.

My network card is a Realtek 8139A, connected through a LAN and gateway, Class C network with no proxy server.
How should I configure it to get online correctly?

Floor1　随风顺	Posted 2002-10-26 00:00
初级用户　Posts 35　Credits 196
I used to use Lynx to dial up to the Internet, and everything was normal. Later, after switching to using a network card to access the Internet, I made the corresponding configuration changes (including DNS, gateway, local IP, subnet mask) But then it stopped working, always prompting that the remote host could not be found. I don't know what's going on. Also, after I run the Packet driver for the network card under the Win98 DOS-Prompt, the whole system goes offline. My network card is a Realtek 8139A, connected through a LAN and gateway, Class C network with no proxy server. How should I configure it to get online correctly?

Floor2　Wengier	Posted 2002-10-26 00:00
系统支持　Posts 10,521　Credits 27,736
If it supports DHCP, you can directly set the IP address to DHCP mode. Do not load the Packet driver in a DOS window; it can only be loaded under pure DOS.

Floor3　kickout	Posted 2002-10-27 00:00
高级用户　Posts 135　Credits 667
How do you configure lynx?

Floor4　Wengier	Posted 2002-10-27 00:00
系统支持　Posts 10,521　Credits 27,736
Just modify the contents of the LYNX.CFG file; there are instructions inside.