After reading the above instructions, I'm still not very clear. Can you give an actual operation example for me to refer to? For example, the one I'm using is an IBM - USB1.1 hard disk. How should I do it? And there's a question about DUSE. I would like to ask. I enter c:\duseldr.com c:\duse.exe under DOS. After running, I get:
DUSE version 4.2 Build 65 (general)
DOS USB Stack with USB Storage Extensions
Copyright Cypress Semiconductor, 2000 - 20002
UHCI USB Controller initialized
UHCI USB Controller initialized
............
At this time, the hard disk's indicator light is on. {Does this mean that the hard disk has been driven? If so, what should I do next}
At the same time, my keyboard is invalid and I can't perform any operation. {May I ask what the reason is}
DUSE version 4.2 Build 65 (general)
DOS USB Stack with USB Storage Extensions
Copyright Cypress Semiconductor, 2000 - 20002
UHCI USB Controller initialized
UHCI USB Controller initialized
............
At this time, the hard disk's indicator light is on. {Does this mean that the hard disk has been driven? If so, what should I do next}
At the same time, my keyboard is invalid and I can't perform any operation. {May I ask what the reason is}
