China DOS Union

The following is the statement quoted from wewesun on 2003-10-23 17:00:33:
LZ, after I downloaded and extracted it, it's 1.46MB, which can't fit on a single floppy disk!!
What should I do?!

Have you read the INSTALL.TXT installation instruction file?

LZ: Can you access the shared resources of the network neighborhood after startup?

The following is the speech of yjxhfy on 2003-10-23 20:45:35:
LZ: Can you access the shared resources of the network neighborhood after startup?

It is completely impossible because there are too many types of network cards, so it is very impractical to add this function.

What the LZ said is right!
If each network card is made like that, it will take a lot of time!
And it's not necessary at all!
LZ, I have an original IBM external hard drive, 12.5G, which can't be driven by duse 4.4 or 4.9. What's the matter?!

I used this bootable disk. The way to use it should be to directly open the MSDOS710.IMG file with WinImage and extract the files inside to drive a:. However, I can't boot my computer with it. What's the matter? I'm using the NTFS file format and the XP Pro system.

My system is winxp, all disks are in NTFS format and the files in them are encrypted. After using this bootable disk, I found the NTFS partition but couldn't read the files. Also, my USB external hard drive couldn't be found, and it showed a loading failure when plugged in. What should I do??????

Hello friend:
I'm a newbie. I want to ask you how to load Chinese display when using the Super MS-DOS Boot Disk.
Thanks!

Wengier:
Hello, I downloaded your super boot disk and used it. It's very good!! Indeed classic. But I found a problem and want to solve it by myself, but I'm not capable enough. I hope you can give me some advice:
The "boot CD" made with the super boot disk cannot boot from the floppy drive because the floppy drive A is virtualized by the CD, so booting from the floppy drive is booting from the floppy drive B. But I can't modify MSDOS.BS in the BOOT folder to make it boot from the floppy drive B. Can you tell me how to do it???

Thanks!!!

I think this bootable disk is still very useful. But why can't Chinese be displayed on the bootable disk I made with this article? Thanks for the guidance.

The following is the speech of yb22 on 2003-10-30 9:39:53:
I think this bootable disk is still very useful. Just why can't the bootable disk I made according to this article display Chinese?
Thank you for your guidance.

Load XZL directly according to the instruction file or prompt information.

This bootable disk selects the third and fourth items to boot. My USB flash drive cannot be driven (freezes, no response when pressing any key, displaying scan......). Also, selecting the third item shows an error on line 28 of config.sys. (The USB flash drive is Longsys.)

Can scanreg\restore be run under this DOS?

Although I'm late, I also support!

I am using a BH7 motherboard and also have the problem that the third and fourth items cannot be started.
The specific situation is that after loading DUSE, when loading the next DEVICEHIGH device, it crashes.
When all are changed to DEVICE=, it can start normally.
Or without loading DUSE, other devices can all use DeviceHihg and start normally.

What do the several boot menus of the Super Universal MS-DOS Boot Disk mean?