|
hcz
初级用户
 
积分 20
发帖 10
注册 2005-10-8
状态 离线
|
『楼 主』:
破解COMS开机密码另类方法
使用 LLM 解释/回答一下
如果你的BIOS是可以插拔,可以拔下来装入另一块主板不就可以进入DOS了吗!虽然麻烦但没有放电破坏性大,也较有技术含量吗!
If your BIOS is removable, you can just pull it out and insert it into another motherboard to enter DOS! Although it's cumbersome, it's not as destructive as discharging, and it's also relatively technical!
|
|
2005-10-9 00:24 |
|
|
Michael
钻石会员
       
积分 10046
发帖 3039
注册 2002-11-11
状态 离线
|
『第 2 楼』:
使用 LLM 解释/回答一下
是CMOS,
放电哪有什么破坏性,取下电池10分钟就可以了。比泡方便面还简单。
It's CMOS. There's no destructive thing about discharging. Just take out the battery for 10 minutes. It's simpler than making instant noodles.
|

简单就是美 |
|
2005-10-9 12:57 |
|
|
不得不爱
超级版主
         我爱DOS
积分 5310
发帖 2044
注册 2005-9-26 来自 四川南充
状态 离线
|
|
2005-10-9 18:01 |
|
|
chujiafu
银牌会员
    
积分 1337
发帖 594
注册 2004-5-26 来自 安徽 宿州
状态 离线
|
『第 4 楼』:
使用 LLM 解释/回答一下
放电这种方法似乎更简便易行。
The method of discharging seems to be simpler and more feasible.
|
|
2005-10-9 18:08 |
|
|
luowuqing
新手上路

积分 3
发帖 1
注册 2005-10-10 来自 威海
状态 离线
|
『第 5 楼』:
使用 LLM 解释/回答一下
把电池拿下来比较方便,而且安全,不知道你是怎么比较的。。。
It's more convenient and safe to take the battery out. I don't know how you compared it...
|
|
2005-10-10 18:13 |
|
|
hcz
初级用户
 
积分 20
发帖 10
注册 2005-10-8
状态 离线
|
『第 6 楼』:
破解COMS开机密码另类方法
使用 LLM 解释/回答一下
放电会清除COMS设置不危险吗。或许我的方法也不怎么好。
Discharging will clear the COMS settings, isn't that dangerous? Maybe my method isn't very good either.
|
|
2005-10-14 06:03 |
|
|
zh0159
新手上路

积分 14
发帖 3
注册 2005-10-10
状态 离线
|
『第 7 楼』:
使用 LLM 解释/回答一下
关机!拿下COMS电池,用导线短路一下电池座两极,马上即清除(不用等10分钟了,一定记住是在关机把电源状态下)
有些主板有CMOS清除帽的,按要求插拔就行了
PS:现在的BOIS芯片好多都是直接焊在主板上了,根本不能拔
Shut down! Remove the CMOS battery, short-circuit the two poles of the battery holder with a wire, and it will be cleared immediately (no need to wait for 10 minutes, be sure to remember that it is under the power-off state when shutting down)
Some motherboards have CMOS clear caps, just plug and unplug according to the requirements
PS: Many current BIOS chips are directly soldered on the motherboard and cannot be removed at all
|
|
2005-10-14 11:02 |
|
|
dos2006
新手上路

积分 14
发帖 18
注册 2005-10-27
状态 离线
|
|
2005-10-28 11:32 |
|
|
mj0930
新手上路

积分 4
发帖 2
注册 2005-10-27
状态 离线
|
|
2005-10-28 22:51 |
|
|
linuxrenfei
新手上路

积分 2
发帖 1
注册 2005-11-15
状态 离线
|
『第 10 楼』:
哪里要拿下电池啊
使用 LLM 解释/回答一下
用导线接一下电池旁边的跳线,1秒钟就够了!这叫短路
Connect the jumper next to the battery with a wire for about 1 second! This is called a short circuit
|
|
2005-11-15 01:08 |
|
|
taylorsir
新手上路

积分 4
发帖 2
注册 2005-11-15 来自 威海
状态 离线
|
|
2005-11-15 19:00 |
|
|
taylorsir
新手上路

积分 4
发帖 2
注册 2005-11-15 来自 威海
状态 离线
|
|
2005-11-15 19:11 |
|
|
sf532925
新手上路

积分 2
发帖 1
注册 2005-11-18
状态 离线
|
『第 13 楼』:
使用 LLM 解释/回答一下
It can't be that it only takes less than 10 minutes to discharge, right? Just 10 seconds is enough :P:P:o
|
|
2005-11-18 15:03 |
|
|
yuren008
初级用户
 
积分 72
发帖 30
注册 2005-11-16 来自 中国
状态 离线
|
『第 14 楼』:
使用 LLM 解释/回答一下
有个问题想在这里问一下,如果是品牌电脑,这样放电后品牌电脑的LOGO会失去,而还原成BIOS的开机LOGO吗?再想问一下,Award BIOS开机图案是能源之星,而AMI BIOS开机图案是左面三个红色的三角叠在一起,右面是个蔚蓝色的地球也有个象Award BIOS一样的五角星在上面,是这样的吗?
There is a question here. If it's a brand computer, after such power discharge, will the brand computer's logo be lost and restored to the BIOS boot logo? Then, another question: The Award BIOS boot pattern is the Energy Star, and the AMI BIOS boot pattern is three red triangles stacked on the left, and a cyan earth on the right with a five-pointed star like the Award BIOS on it. Is that the case?
|
|
2005-11-18 20:49 |
|
|
JonePeng
金牌会员
      D◎$ Fαп
积分 4562
发帖 1883
注册 2004-1-19 来自 广东广州
状态 离线
|
『第 15 楼』:
使用 LLM 解释/回答一下
Originally posted by yuren008 at 2005-11-18 20:49:
放电后品牌电脑的LOGO会失去,而还原成BIOS的开机LOGO吗?
那个LOGO是全屏幕的LOGO,而且是固化在BIOS芯片上的,不会丢失。只有用BIOS刷新LOGO工具的情况下,才可以改写LOGO。
取出电池后,BIOS的设置会还原为默认值。其实在BIOS的设置里可以设置为允许或禁止显示全屏幕的LOGO。通常是“Full Screen Logo”选项。
Originally posted by yuren008 at 2005-11-18 20:49:
After discharging, will the brand computer's LOGO be lost and restored to the BIOS boot LOGO?
That LOGO is a full-screen LOGO and is solidified in the BIOS chip, so it will not be lost. Only when using a BIOS logo refresh tool can the LOGO be rewritten.
After removing the battery, the BIOS settings will be restored to default values. In fact, in the BIOS settings, you can set whether to allow or prohibit displaying the full-screen LOGO. Usually, it is the "Full Screen Logo" option.
|

----====≡≡≡≡ 我的至爱,永远是MSDOS!≡≡≡≡====----
|
|
2005-11-19 23:55 |
|