『楼 主』:
使用MS-DOS 7.10超级启动盘无法找到C盘
使用 LLM 解释/回答一下
本人的电脑使用的是番茄花园sp2sata系统，250G硬盘，所有盘都是ntfs系统，512×2M内存。从dos之家下载了MS-DOS 7.10超级启动盘之后，用WinImage把MSDOS710.IMG解压到了A盘（软盘），然后从软驱启动，从第二个选项进入,A盘可以用DOS显示其内容，可是当我想要显示C盘内容的时候，输入NTFSDOS命令,系统提示
general failure reading drive C
abort retry fail?
从第三项进入（也就是可以支持NTFS的那项），运行不了多久等出现
USB Drive support enabled
Drive C:
Drive D:
就死机了。有意思的是，如果我记得没错，应该报过把某种工具成功输入到D：但是好像也说过没有发现硬盘。
从第四项进入运行的更多些，到Unicode support is enabled 就停止了。也警告过没发现硬盘。
当我换成在另一台20G的电脑上启动时，也找不到硬盘，那台电脑用的是win2000.全部是fat32系统，请教大侠甚解？
Last edited by sdjk on 2008-4-2 at 02:45 PM ]
My computer is using the Tomato Garden SP2 SATA system, with a 250G hard drive, all partitions are NTFS system, and 512×2M memory. After downloading the MS-DOS 7.10 Super Boot Disk from DOS Home, I used WinImage to extract MSDOS710.IMG to drive A (floppy disk), then booted from the floppy drive. When entering from the second option, the content of drive A can be displayed using DOS. But when I want to display the content of drive C, I enter the NTFSDOS command, and the system prompts:
general failure reading drive C
abort retry fail?
When entering from the third option (that is, the one that supports NTFS), it can't run for long and then appears:
USB Drive support enabled
Drive C:
Drive D:
and then freezes. Interestingly, if I remember correctly, it should have reported that a certain tool was successfully input to D: but also said that no hard drive was found.
When entering from the fourth option, it runs longer, and stops when Unicode support is enabled. It also warns that no hard drive is found.
When I switched to booting on another computer with a 20G hard drive, it also couldn't find the hard drive. That computer is using Win2000, all are FAT32 systems. Please, great experts, help me understand this!
Last edited by sdjk on 2008-4-2 at 02:45 PM ]
|
