想来想去还是法这边把
升级到7.10，
如果用7.10的启动盘启动，然后sys x<img src="images/smilies/face-sad.png" align="absmiddle" border="0">我装dos622的盘符)，
再把Wengier做的7.10完整版考上去，
上次这么做升级成功并且运行良好，但我在x盘上靠了个wengier做的logo.sys
出现了个mm的图片后，到现在无论把这个logo.sys删，或再次sys,format /s后
都不能正常启动了
晴帮忙看看
谢谢
After thinking it over, I still think it's better to do it this way.
Upgrade to 7.10.
If you boot with the 7.10 boot disk and then run sys x: (the drive letter where I installed DOS 622),
then copy the full version of 7.10 made by Wengier onto it,
Last time I did this upgrade successfully and it worked well, but I put a logo.sys made by Wengier on drive x:
After an mm picture appeared, now no matter if I delete this logo.sys, or run sys again, format /s again, it can't boot normally.
Qing, please take a look.
Thank you
