VMWare中所用的网卡是AMD PCNET Familty Ethernet Adapter没错，但VPC中所用的网卡应该是Digital Semiconductor 2104x/2114x 10/100 mbps Ethernet Controller吧？事实上，我自己就主要是在虚拟机（包括VMWare、VPC 2003、QEmu等）中使用MSClient 3.0精简版来和真实机直接连网而且也能上网，直接输入MSNET命令即可启动，十分方便。现上传到以下地址。
http://cndos.l009.com/soft/vmnet.zip
说明：目前其中的VMNET.DOS为VMWare网卡驱动，故在VMWare中只需直接输入MSNET命令启动即可；若在VPC中用则直接将这个VMNET.DOS用里面的VPCNET.DOS替换然后直接输入MSNET命令启动即可，不需做任何其它修改。另外，由于局域网是通过灵活快捷的NetBEUI协议连接，故如想与主机连接的话主机中也需要安装NetBEUI协议。
The network card used in VMWare is indeed the AMD PCNET Familty Ethernet Adapter. But the network card used in VPC should be the Digital Semiconductor 2104x/2114x 10/100 mbps Ethernet Controller, right? In fact, I mainly use the MSClient 3.0 lightweight version in virtual machines (including VMWare, VPC 2003, QEmu, etc.) to directly connect to the real machine for networking and can also access the internet. Just enter the MSNET command to start it, which is very convenient. Now uploaded to the following address.
http://cndos.l009.com/soft/vmnet.zip
Instructions: Currently, the VMNET.DOS in it is the VMWare network card driver, so in VMWare, you just need to directly enter the MSNET command to start it; if used in VPC, directly replace this VMNET.DOS with the VPCNET.DOS inside and then directly enter the MSNET command to start it, without any other modifications. Also, since the local area network is connected through the flexible and fast NetBEUI protocol, if you want to connect with the host, the host also needs to install the NetBEUI protocol.
