『楼 主』:
每次重启,0扇区都会被改写
使用 LLM 解释/回答一下
使用ghost “DISK TO DISK” NT3.51的硬盘后(源盘:2G/5G,目标盘:6G/6.4G),新盘不能引导系统,于是用diskrw查看0扇区,发现整个扇区内容全部被改写成非0内容,55AA也没有了,但是再次执行diskrw 0 0 1 /l /p,扇区内容却又恢复正常了
每次重启后,查看目标盘都是这种情况,第一次全被改写,再次查看就正常了。
于是把目标盘换成一块不太好的2G盘,就没有出现这种问题,虽然仍然不能引导系统。
为什么会出现这种0扇区临时被改写的问题呢?
求赐教!!
After using the ghost "DISK TO DISK" for the NT3.51 hard drive (source disk: 2G/5G, target disk: 6G/6.4G), the new disk cannot boot the system. Then, using diskrw to view the 0th sector, it was found that the entire sector content was rewritten to non-zero content, and 55AA was also gone. But when executing diskrw 0 0 1 /l /p again, the sector content returned to normal.
Every time after restarting, viewing the target disk is like this. The first time it was all rewritten, and the next time it was normal when viewed.
So, replacing the target disk with a not-so-good 2G disk, this problem did not occur, although it still cannot boot the system.
Why does this problem of the 0th sector being temporarily rewritten occur?
Please give advice!
|