『楼 主』:
msclient3.0安装到最后一步时，提示SYSTEM.INI出错
使用 LLM 解释/回答一下
msclient3.0安装到最后一步时，提示SYSTEM.INI出错
提示什么在安装盘中的SYSTEM.INI文件不可写或缺少。
要继续点回车。
点击回车后，就回到DOS下。再启动后，不加载网络。
查看，c:/net文件夹下的SYSTEM.INI发现，其中的一些参数如，
username,lanroot,groupname等等，都没有设定值，正常情况下，是有的。
我要做的机器是一种工业化钢材材质分析设备，由DOS系统控制。
客户要求DOS连XP。在XP上我们用VB做了一个程序，用于DOS分析后数据的校验。所以需要联网共享DOS下数据。
以下为我的操作步骤：
用PE启动虚拟XP系统。插入U盘拷入MSCLIENT安装程序NETSETUP.
DEF-530网卡驱动。WG1049补丁。
重启后，进入DOS下。
安装NETSETUP，成功识别网卡，但在最后一步由于SYSTEM.INI的错误导致失败。不知道为什么。
注：成功做过DOS与XP联网。
请教高人。这是未为什么，！！！！！！！！！！！！！！！！！！！
When installing msclient 3.0 to the last step, it prompts that SYSTEM.INI has an error. It prompts that the SYSTEM.INI file in the installation disk is not writable or is missing. Press Enter to continue. After clicking Enter, it returns to DOS. After restarting, the network is not loaded. Check the SYSTEM.INI in the c:/net folder and find that some parameters such as username, lanroot, groupname, etc., have no set values. Under normal circumstances, they are there. The machine I am working on is an industrial steel material analysis equipment controlled by the DOS system. The customer requires DOS to connect to XP. On XP, we used VB to make a program for checking the data after DOS analysis. So we need to share the data under DOS over the network. The following are my operation steps: Boot into the virtual XP system with PE. Insert the USB flash drive to copy the MSCLIENT installation program NETSETUP, DEF-530 network card driver, and WG1049 patch. Restart and enter DOS. Install NETSETUP, the network card is successfully recognized, but it fails at the last step due to the error of SYSTEM.INI. I don't know why. Note: It has been successfully done to connect DOS with XP. Ask the expert. Why is this,!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
|
