『楼 主』:
超级通用MSDOS 7.1 启动盘 问题
使用 LLM 解释/回答一下
MSDOS 7.1 启动盘 问题
我做了一些测试
1)
选择1项后,不兼容NTFS4DOS 1.9, 也不兼容 1.4 现象是找不到NT分区了.
不知道哪个驱动挂错了,单独挂上HIMEM.SYS 和 EMM386 就可以加载NTFS4DOS.
其他菜单没去试验.
更有意思的是,NTFS4DOS 1.9装在软盘上不运行, 1.4可以.
2) 找不到FC和COMP外部命令了. ROM-DOS也没有. 只有找到完整MS-DOS71才行.
3) 我发现ROM-DOS的HIMEM可以用UPX压缩,压缩以后只有3K,还能正常用.
EMM386也是ROM-DOS的体积小.
用PCTOOLS里带的MI.COM代替MEM,还能节省很多磁盘空间. 8.4k
XCOPY可以用ROM-DOS代替,只有一个文件,是否支持汉字,还没有测试.
MSDOS 7.1 Boot Disk Issues
I did some tests
1)
After selecting option 1, it is incompatible with NTFS4DOS 1.9, and also incompatible with 1.4. The phenomenon is that the NT partition cannot be found.
I don't know which driver is mismounted. Just mounting HIMEM.SYS and EMM386 alone can load NTFS4DOS.
Other menus haven't been tested.
More interestingly, NTFS4DOS 1.9 doesn't run when installed on a floppy disk, but 1.4 does.
2) Can't find the FC and COMP external commands. ROM-DOS doesn't have them either. Only the complete MS-DOS 71 can be found.
3) I found that the HIMEM of ROM-DOS can be compressed with UPX. After compression, it is only 3K and can still be used normally.
EMM386 is also small in volume in ROM-DOS.
Using MI.COM from PCTOOLS instead of MEM can also save a lot of disk space. 8.4k
XCOPY can be replaced with ROM-DOS, which is only one file. Whether it supports Chinese characters hasn't been tested yet.
|