|
skybliu
初级用户
 
积分 111
发帖 3
注册 2004-5-11
状态 离线
|
『楼 主』:
移动硬盘能否做启动盘
使用 LLM 解释/回答一下
请教各位专家:
小弟有一块自己装的移动硬盘:日立40G;IBM的盒。
请教各位能否做一个支持NTFS格式下GHOST系统的启动盘?
如果能,请教该怎么做!
小弟先行谢谢啦!
Dear experts:
Little brother has a self-assembled external hard drive: Hitachi 40G; IBM case.
I would like to ask you all if I can make a bootable disk that supports GHOST system under NTFS format?
If yes, please teach me how to do it!
Little brother thanks in advance!
|
|
2004-5-11 00:00 |
|
|
shigzh
初级用户
 
积分 142
发帖 15
注册 2004-5-15
状态 离线
|
『第 2 楼』:
使用 LLM 解释/回答一下
用SYS传输系统文件,bios 第一引导设为USB-HDD,外接5V电源给移动硬盘,接上USB线,在电脑检测硬件前,外接的5V电源,只能使移动硬盘转动而移动硬盘合上的指示灯不能亮,这一点一定要配合好,电脑检测硬件后移动硬盘合上的指示灯就会亮,如先亮,电脑检测硬件后移动硬盘合上的指示灯就灭,则不能启动计算计机,乘下的可参照在MD-DOS710超级启动盘。
Use SYS to transfer system files, set the BIOS first boot to USB-HDD, connect an external 5V power supply to the mobile hard disk, connect the USB cable. Before the computer detects hardware, the external 5V power supply can only make the mobile hard disk spin but the indicator light of the mobile hard disk closing cannot be on. This must be well coordinated. After the computer detects hardware, the indicator light of the mobile hard disk closing will be on. If it is on first and then goes off after the computer detects hardware, the computer cannot be booted. The rest can refer to the MD-DOS710 super boot disk.
|
|
2004-5-15 00:00 |
|
|
wfn2000
初级用户
 
积分 144
发帖 15
注册 2004-3-31
状态 离线
|
『第 3 楼』:
使用 LLM 解释/回答一下
能否说的具体一点,还是不大明白
Can you be more specific? I still don't quite understand.
|
|
2004-7-12 00:00 |
|
|
moyu
初级用户
 
积分 158
发帖 22
注册 2004-3-24
状态 离线
|
『第 4 楼』:
使用 LLM 解释/回答一下
我也想知道。
麻烦谁能说清楚一点,多谢。
I also want to know.
Please someone make it clear, thanks a lot.
|
|
2004-7-13 00:00 |
|
|
朝天一棍
初级用户
 
积分 107
发帖 2
注册 2004-2-16
状态 离线
|
『第 5 楼』:
使用 LLM 解释/回答一下
我前两天试过,可以的哈!
只要主板的BIOS支持USB-HDD启动就没有问题的!
将BIOS中的第一启动盘设置为USB-HDD就可以【当然移动硬盘上要有可以启动的操作系统】……
至于移动硬盘上的操作系统,最简单的可以使用DOS的format /s来制作【估计98什么的也可以】……
I tried it the other day, and it's okay!
As long as the motherboard's BIOS supports USB-HDD boot, there's no problem!
Set the first boot device in the BIOS to USB-HDD. ...
As for the operating system on the external hard drive, the simplest way is to use DOS's format /s to make it ...
|
|
2004-7-13 00:00 |
|
|
wfn2000
初级用户
 
积分 144
发帖 15
注册 2004-3-31
状态 离线
|
『第 6 楼』:
使用 LLM 解释/回答一下
我的主板也支持USB-HDD但为什么不行
Why doesn't it work even though my motherboard supports USB-HDD?
|
|
2004-7-16 00:00 |
|
|
chenall
银牌会员
    
积分 1276
发帖 469
注册 2002-12-23 来自 福建泉州
状态 离线
|
『第 7 楼』:
使用 LLM 解释/回答一下
移动硬盘上没有主分区或激活主分区或没有系统文件
There is no primary partition on the mobile hard disk, or the primary partition is not activated, or there are no system files
|

QQ:366840202
http://chenall.net |
|
2004-7-17 00:00 |
|
|
shigzh
初级用户
 
积分 142
发帖 15
注册 2004-5-15
状态 离线
|
『第 8 楼』:
使用 LLM 解释/回答一下
在WIN9X系统中用SYS传输系统文件(FORMAT /S X:也行),bios 中第一引导盘设为USB-HDD,把移动硬盘接到电脑上,关电重新开机,电脑检测硬件,移动硬盘指示灯由灭变亮,这样即可引导计算机。
要注意的是重启动不能使移动硬盘引导计算计机,因为重启动时移动硬盘指示灯是亮着的,电脑检测硬件后,移动硬盘指示灯会灭,这样就不能引导计算机。一般要关电重新开机才行
In the WIN9X system, use SYS to transfer system files (FORMAT /S X: also works). Set the first boot disk in the bios to USB-HDD. Connect the mobile hard drive to the computer, turn off the power and restart, the computer detects the hardware, and the indicator light of the mobile hard drive changes from off to on, then it can boot the computer.
It should be noted that restarting cannot make the mobile hard drive boot the computer, because when restarting, the indicator light of the mobile hard drive is on, and after the computer detects the hardware, the indicator light of the mobile hard drive will go off, so it cannot boot the computer. Generally, you need to turn off the power and restart again to work.
|
|
2004-7-22 00:00 |
|
|
酒鬼
初级用户
 
积分 106
发帖 3
注册 2004-7-23
状态 离线
|
|
2004-7-24 00:00 |
|