Board logo

标题: 急求Geoworks Ensemble 2.0 [打印本页]

作者: humct     时间: 2006-6-10 18:16    标题: 急求Geoworks Ensemble 2.0
本人急需Geoworks Ensemble 2.0 ,请问有谁知道从哪可以下载到?

作者: liuboadsl     时间: 2006-6-10 18:38
又来了。

作者: 雨露     时间: 2006-6-10 20:46
在电骡上可以搜索得到,我刚下载完,是5张盘的,还没有安!下面是其说明:

Geoworks Ensemble 2.0
Geoworks May 1993

* Minimum Hardware:
+ 286 CPU (386 recommended)
+ CGA display and adapter
+ 1 megabyte memory
+ 15 megabytes free disk space
+ Floppy drive compatible with host PC
+ Available serial port
* Minimum Software:
+ MSDOS 3.0 or DR DOS 5.0

5 - Disks, use 1.2Mb or 1.44Mb floppies
Unzip each to a new or newly formatted floppy
You must install from floppy for this to
install. If you get an error during installation
be sure to have a printer attached to LPT 1,
seems if you don't you can get an error even if
no printer driver is installed.

Labels for disks:
Disk1= Geos_1
Disk2= Geos_2
Disk3= Geos_3
Disk4= Geos_4
Disk5= Geos_5



Troubleshooting startup:
Q: During Setup I get a divide by "0" error.

A: Make sure you have a printer connected and turned on.
Or change the line in GEOS.INI that reads:
continueSetup = true to read:
continueSetup = false
and install the printer thru Geos and not Setup.

Q: When I try to start GEOS, I get a message saying that GEOS is
unable to find /userdata/fonts

A: This could be any of several things. GEOS interacts with the
hardware at a very low level, and it doesn't work well with anything
that redirects the drives. Specifically:
* Windows 32 bit file access SOMETIMES causes problems.
* Networked drives cause problems for GEOS system files, although
you can usually save data to a networked drive.
* DOS emulation under Linux or Macintosh causes problems because
GEOS tries to directly interact with hardware that just isn't
there.

Q: I switched from MS-DOS/PC-DOS to DR-DOS and GEOS won't load, even
after i run SETUP. What am I doing wrong?

A: Make sure that you have FILES=120 or MORE. DR-DOS uses files
differently and needs more available. NWDOS USUALLY works with about
50 files open.


Enjoy.....Ho !

作者: humct     时间: 2006-6-10 21:05
afnspy
能否把文件上传到论坛上来,谢谢你!

作者: 雨露     时间: 2006-6-10 22:27
等安装成功后上传比较好!明天再说吧!

作者: 雨露     时间: 2006-6-11 11:07
这个玩意没有打印机很难搞定它!

作者: humct     时间: 2006-6-11 12:40
公司上的那台老机器有打印机
型号LQ-1600K
不知行不行

作者: humct     时间: 2006-6-11 12:41
请afnspy上传

作者: 雨露     时间: 2006-6-11 17:27
文件太大,传不上,一传就死机!

作者: ppshow     时间: 2006-6-11 20:10
汗,论坛没空间上传了。。。
传cndos.l009.com又太慢了~

http://cndos.l009.com/filedown/files/Geoworks - Ensemble 2.0 - Installation Disks.zip

Last edited by ppshow on 2006-6-11 at 20:54 ]

作者: 雨露     时间: 2006-6-11 20:52
我也不知道,这个论坛对我上传文件很"抵触"!想尽办法也没有用,对不起!不是我不想帮忙!
我昨晚确实下到了这个系统,可是安装到每2张就出毛病了,还好,有个网友上传了一份给我,可以正常安装的!

你的好像没有传完的吧?

Last edited by afnspy on 2006-6-11 at 20:56 ]

作者: 雨露     时间: 2006-6-11 20:59
Originally posted by ppshow at 2006-6-11 20:10:
汗,论坛没空间上传了。。。
传cndos.l009.com又太慢了~

http://cndos.l009.com/filedown/files/Geoworks - Ensemble 2.0 - Installation Disks.zip

Last edited by ppsh ...

跟我一样,我用IE根本不行,用Mozilla Firefox才0.08KB/S,要很长时间就放弃了!
用了最流行的统一网关也不行,真气死我了

Last edited by afnspy on 2006-6-11 at 21:03 ]

作者: ppshow     时间: 2006-6-11 21:02
没传完...没办法了,传到cndos.l009.com,现在才14.68%,已经传了一个多小时了.慢慢传吧!
这个版本有问题吗?我从电驴下的。

作者: 雨露     时间: 2006-6-11 21:05
解压后是5个文件夹加一个说明是吧?那个不行的,我试过!
用上"yksoft1 老大"的那个可以!

Last edited by afnspy on 2006-6-11 at 21:07 ]

作者: ppshow     时间: 2006-6-11 21:06
哦。。。那算了。。。汗~~~

作者: 雨露     时间: 2006-6-11 21:08
实在不行,我上传到网盘吧!

已上传到http://free.ys168.com/?afnspy在ShareData文件夹下!

安装成功了的同志,介绍一下经验哦!

Last edited by afnspy on 2006-6-11 at 21:26 ]

作者: ppshow     时间: 2006-6-11 21:31
已下。谢谢。。。

作者: 雨露     时间: 2006-6-12 22:55
修正一下前天所说的:
电骡下的文件名为 PC Geos (Geoworks) V2.0 from '93, not the New Deal trial version是可以用的!

下载地址为
ed2k://|file|Geoworks%20-%20Ensemble%202.0%20-%20Installation%20Disks.zip|4655587|B6540A9E4A4837082A27BFBBD8250F02|/好像无法安装成功!

Last edited by afnspy on 2006-6-17 at 16:53 ]

作者: humct     时间: 2006-6-17 15:03
十分感谢afnspy上传GEOS
本人感激不禁!!!!!!!!!!!!
谢谢afnspy!谢谢afnspy!谢谢afnspy!谢谢afnspy!谢谢afnspy!谢谢afnspy!