Originally posted by bush at 2006-1-17 11:51 PM:
请问brglng：
你是怎样设置的呢？我正在学习ADSL上网，但还没弄好。
基本上和Windows里的设置一样。由于我是使用路由器的，所以就把"My_ip"设置成192.168.0.2（可以自己在路由器设置中调整），"gateway"（网关）设置成路由器的地址，比如我就是192.168.0.1，"netmask"（子网掩码）一般为255.255.255.0，更重要的是设置DNS服务器（namesever），这要看地区，不同的地区DNS服务器不同，像我这里就是202.96.209.6和202.96.209.133。然后在启动Lynx前加载好网卡的Packet驱动，并且设置LYNX_CFG环境变量为./lynx.cfg，进入lynx所在目录敲“lynx”就可以啦！
Originally posted by Wengier at 2006-1-18 12:09 AM:
如果用路由器接ADSL上网，在路由器中设置好上网方式后，Lynx，以及其它使用Wattcp的程序，如使用DHCP确不能自动分配IP地址，需要手工设置IP地址才行〠...
哦！原来如此！我就是用路由器上的。这样的话我必须把路由器配置成固定IP了……
另外不知是否有支持Unicode的汉字系统？
Last edited by brglng on 2006-1-18 at 13:54 ]
Originally posted by bush at 2006-1-17 11:51 PM:
May I ask brglng:
How did you set it up? I'm learning about ADSL internet access, but I haven't got it working yet.
Basically the same as in Windows. Since I'm using a router, I set "My_ip" to 192.168.0.2 (you can adjust it in the router settings yourself), set "gateway" (gateway) to the router's address, for example, mine is 192.168.0.1, "netmask" (subnet mask) is generally 255.255.255.0, and more importantly, set the DNS server (namesever). This depends on the region, and different regions have different DNS servers. Like here, it's 202.96.209.6 and 202.96.209.133. Then load the network card's Packet driver before starting Lynx, and set the LYNX_CFG environment variable to./lynx.cfg. Go to the directory where Lynx is located and type "lynx" to get started!
Originally posted by Wengier at 2006-1-18 12:09 AM:
If you use a router to connect to ADSL internet access, after setting up the internet access method in the router, Lynx, and other programs using Wattcp, such as using DHCP, it cannot automatically assign an IP address, and you need to set the IP address manually...
Oh! So that's how it is! I'm using a router. In that case, I have to configure the router to a fixed IP...
Also, I wonder if there is a Chinese character system that supports Unicode?
Last edited by brglng on 2006-1-18 at 13:54 ]
