Originally posted by llm at 2006-5-31 12:09 PM:
我用过这个版本，当时是测试版
刚刚测了一下，这个是升级版，不能全新安装
升级版的dos很好安装的，先按F3退出安装界面，然后在命令行下用sys命令把系统文件传至c:盘。然后再用第一张软盘重启进入安装界面，它就会认为你的硬盘上已有dos系统了。
Originally posted by llm at 2006-5-31 12:09 PM:
I used this version, it was a beta version at that time
Just tested it just now, this is an upgraded version, cannot be installed cleanly
It's very easy to install the upgraded DOS. First, press F3 to exit the installation interface, then use the sys command in the command line to transfer the system files to the C: drive. Then restart with the first floppy disk and enter the installation interface, and it will think that there is already a DOS system on your hard drive.
