320G的串口移动硬盘不能引导DOS镜像
一块320G的串口移动硬盘,我把它做成WINPE+DOS引导,WINPE能正常引导,用GRLDR加载DOS.IMA镜像时出错,无法进入DOS系统。
第一分区FAT格式,250M,设为活动。盘内容如图:
主分区 WinPE 的内容:
boot.ini 的内容
menu.lst 的内容
同样的内容和配置在一个80G的并口移动硬盘和一个40G的并口移动硬盘上运行,均能正常引导,应该说DOS.IMA镜像不会有问题,但在320G的串口移动硬盘上就不行,引导后只有光标在闪动和移动硬盘批示灯在闪动,机器也未死机,就是不能进入DOS界面,请高手帮我看看错在何处……
Last edited by jh1688 on 2010-4-25 at 21:47 ]
A 320G Serial Port Mobile Hard Drive Cannot Boot DOS Image
A 320G serial port mobile hard drive. I made it into a WINPE + DOS boot. WINPE can boot normally. When using GRLDR to load the DOS.IMA image, an error occurs and cannot enter the DOS system.
The first partition is in FAT format, 250M, set as active. The contents of the disk are as shown in the picture:
Contents of the primary partition WinPE:
Contents of boot.ini
Contents of menu.lst
The same content and configuration run normally on an 80G parallel port mobile hard drive and a 40G parallel port mobile hard drive. It should be said that the DOS.IMA image is not a problem, but it doesn't work on the 320G serial port mobile hard drive. After booting, only the cursor is flashing and the mobile hard drive indicator light is flashing. The machine is not dead, just cannot enter the DOS interface. Please help the expert to see where the mistake is...
Last edited by jh1688 on 2010-4-25 at 21:47 ]